And holes for the sumpguard!
| ausmini https://www.ausmini.com/forums/ |
|
| mini and moke Subframe question https://www.ausmini.com/forums/viewtopic.php?f=2&t=55083 |
Page 1 of 1 |
| Author: | fix8ed [ Mon Jul 13, 2009 1:25 pm ] |
| Post subject: | mini and moke Subframe question |
hey all is there any difference between a mini and moke front subframe? |
|
| Author: | simon k [ Mon Jul 13, 2009 1:27 pm ] |
| Post subject: | |
later moke front subframes have some extra brackets for the bullbar |
|
| Author: | moemoke [ Mon Jul 13, 2009 1:29 pm ] |
| Post subject: | |
Moke subframes have mounts for front bumber. Early ones have mounts on top, later ones have them underneath |
|
| Author: | graham in aus [ Mon Jul 13, 2009 1:38 pm ] |
| Post subject: | |
And holes for the sumpguard!
|
|
| Author: | Convertible Mini [ Mon Jul 13, 2009 1:55 pm ] |
| Post subject: | And also. |
The Moke subframe is actually made of slightly thicker gauge steel Measuring .090". I was tod this by Jack Read years ago. I have never actually measure them though to prove it. |
|
| Author: | poeee [ Mon Jul 13, 2009 2:07 pm ] |
| Post subject: | |
graham in aus wrote: And holes for the sumpguard!
With captive nuts as far as I remember? |
|
| Author: | fix8ed [ Mon Jul 13, 2009 3:16 pm ] |
| Post subject: | |
ok so i have a 67 mini n my dad has a 70 something moke and he wants the motor out of my mini, can we just swap it over? |
|
| Author: | TheMiniMan [ Mon Jul 13, 2009 3:23 pm ] |
| Post subject: | |
diff ratio will most probably be different |
|
| Author: | norton [ Mon Jul 13, 2009 3:43 pm ] |
| Post subject: | |
later Moke ones sit higher above the road |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|