| ausmini https://www.ausmini.com/forums/ |
|
| Engine sizes with oversize bores https://www.ausmini.com/forums/viewtopic.php?f=2&t=55142 |
Page 1 of 1 |
| Author: | 66S [ Wed Jul 15, 2009 7:45 am ] |
| Post subject: | Engine sizes with oversize bores |
Hi guys, Does anybody know the capcities of a 1275 with oversize bores please? .020" 1293 .030" .040' .050" .060" Regards Al |
|
| Author: | sgc [ Wed Jul 15, 2009 9:31 am ] |
| Post subject: | Re: Engine sizes with oversize bores |
66S wrote: Hi guys,
Does anybody know the capcities of a 1275 with oversize bores please? By my spreadsheet it's: .020" 1291.6 .030" 1300.8 .040" 1310.1 .050" 1319.4 .060" 1328.7 |
|
| Author: | Drexxle [ Wed Jul 15, 2009 10:39 am ] |
| Post subject: | |
and they will all differ dependant on how much youve modified everything else. Lapping the block, or head, modifying the head, different pistons, different rods and so on. |
|
| Author: | 66S [ Wed Jul 15, 2009 10:41 am ] |
| Post subject: | |
Thanks Simon. Drexxle, swept volume is just that, bore and stroke. Nothing else influences it. You may be getting confused with compression ratios. Regards Al |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|