by 2 sheets of metal being overlapped... sure...
| ausmini https://www.ausmini.com/forums/ |
|
| moke floor question.......... https://www.ausmini.com/forums/viewtopic.php?f=2&t=55155 |
Page 1 of 1 |
| Author: | Blunder [ Wed Jul 15, 2009 6:29 pm ] |
| Post subject: | moke floor question.......... |
Where the front subframe meets the footwell is it reinforced on a moke!? Does anyone have underside picture of where rear of front subframe mounts!?> thanks |
|
| Author: | mattsmadmini [ Wed Jul 15, 2009 6:32 pm ] |
| Post subject: | |
by 2 sheets of metal being overlapped... sure...
|
|
| Author: | Kennomini [ Wed Jul 15, 2009 6:53 pm ] |
| Post subject: | |
I thought their was a box section down their somewhere but I'm not sure if it's the same area. |
|
| Author: | Timbo [ Wed Jul 15, 2009 9:09 pm ] |
| Post subject: | |
Yep, there's a box section there, sticks down about 2 - 2 1/2 cm at the front. Thats why there are holes in each footwell with one of the subframe mounting bolts down them. Tim |
|
| Author: | drmini in aust [ Wed Jul 15, 2009 9:11 pm ] |
| Post subject: | |
Timbo wrote: Yep, there's a box section there, sticks down about 2 - 2 1/2 cm at the front. Thats why there are holes in each footwell with one of the subframe mounting bolts down them.
Tim My `79 Moke has 5 patch layers above that...  
I will fix it, when I get time and a round tuit... |
|
| Author: | TheMiniMan [ Wed Jul 15, 2009 9:17 pm ] |
| Post subject: | |
Yeah, the moke floors are an inch "higher" than the mini floor pans,,, so there is a step "up" from the rear mounting point of the front frame, & yeah it`s sort of a box section where it mounts |
|
| Author: | david rosenthal [ Wed Jul 15, 2009 9:22 pm ] |
| Post subject: | |
If you want to look at my 67 moke at the set up your welcome. One side is still original and the other I have repaired/replaced. Both had some rust between the metal overlap |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|