I was setting up the adjustable suspension bits and adjusting to standard length for initial installation and just need clarification of terms please.

The instructions say to set the length between the centre of the trunnion (big hole where the bushes go ) and the centre of the swivel pin hole - WTF is that hole ? Do they mean the ball joint?

_________________
David L


My greatest fear in life is that when I die my wife will sell my Mini and tools for the price I told her I paid for them!

They mean you want to set the length to the distance between the flange against which the inner bush sits, and the bolt hole which attaches the other end to the lower suspension arm. Measure that length on your standard arm and set the adjustable one the same.

_________________
Simon

The adventures of an owner builder in the Tallarook Ranges

Swivel pin sounds like a ball joint to me, so that would be the whole you think it is Wombat. I presume your talking about the lower control arm and not the tie bar.