| ausmini https://www.ausmini.com/forums/ |
|
| Rocker Cover Gaskets https://www.ausmini.com/forums/viewtopic.php?f=2&t=55679 |
Page 1 of 1 |
| Author: | slide [ Sun Aug 02, 2009 1:03 pm ] |
| Post subject: | Rocker Cover Gaskets |
Apart from the cork gaskets are there still the re-usable rubber ones available? |
|
| Author: | Rodney [ Sun Aug 02, 2009 1:49 pm ] |
| Post subject: | |
Not that I know.....I made one from a piece of conveyor belt I 'made use of' from work. Pretty thick stuff and it works well. |
|
| Author: | DOZ [ Sun Aug 02, 2009 5:36 pm ] |
| Post subject: | |
I glue the std cork one to the rocker cover and coat the bottom with a smear of grease - can re-use a few times for rocker adjustments etc. Daniel |
|
| Author: | DTrain [ Sun Aug 02, 2009 6:15 pm ] |
| Post subject: | |
be careful with the replacement ones, i bought one and its over an inch short. a bit of heat might have been able to stretch it but i was impatient and it broke |
|
| Author: | MG Rocket [ Sun Aug 02, 2009 6:22 pm ] |
| Post subject: | |
DTrain wrote: be careful with the replacement ones, i bought one and its over an inch short. a bit of heat might have been able to stretch it but i was impatient and it broke
As my remember it, my father in the old days when I was a just a little kid, use to soak cork gaskets in water when they were too small, but the picture is quite fuzzy. |
|
| Author: | 66S [ Mon Aug 03, 2009 7:50 am ] |
| Post subject: | |
Quite correct, hot water. Al |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|