| ausmini https://www.ausmini.com/forums/ |
|
| Cone compressor "loan" needed Adelaide https://www.ausmini.com/forums/viewtopic.php?f=2&t=55715 |
Page 1 of 1 |
| Author: | Blunder [ Mon Aug 03, 2009 12:52 pm ] |
| Post subject: | Cone compressor "loan" needed Adelaide |
Hi all, need to change the knuckle and was wondering if anyone had a cone compressor I could borrow? Pm if u could assist! Many thanks |
|
| Author: | Drexxle [ Mon Aug 03, 2009 12:55 pm ] |
| Post subject: | |
its not tooo difficult to do without one. Just dont bash the crap out of it. |
|
| Author: | floss [ Mon Aug 03, 2009 1:26 pm ] |
| Post subject: | |
I made one. Got threaded bar and some nuts and then locked two nuts together. Got a big thick washer so that it didn't stuff up the metal above the cone. It isn't perfect but it does the job ok. D |
|
| Author: | Blunder [ Mon Aug 03, 2009 1:57 pm ] |
| Post subject: | |
That is one option anyone know what the thread would be? It's a 76 clubman. |
|
| Author: | floss [ Mon Aug 03, 2009 2:37 pm ] |
| Post subject: | |
http://www.ausmini.com/forums/viewtopic ... ess+thread This might help. |
|
| Author: | Blunder [ Mon Aug 03, 2009 4:45 pm ] |
| Post subject: | |
doesn't say thread type... Anyone?! |
|
| Author: | dale 62 [ Mon Aug 03, 2009 5:00 pm ] |
| Post subject: | |
pm sent |
|
| Author: | floss [ Mon Aug 03, 2009 8:02 pm ] |
| Post subject: | |
1/2 UNF I am pretty sure. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|