| ausmini https://www.ausmini.com/forums/ |
|
| . https://www.ausmini.com/forums/viewtopic.php?f=2&t=55746 |
Page 1 of 1 |
| Author: | Mike [ Tue Aug 04, 2009 10:09 am ] |
| Post subject: | . |
l. |
|
| Author: | Wombat [ Tue Aug 04, 2009 10:45 am ] |
| Post subject: | |
I've heard they required a bit if tightening but at the same time make sure the O ring is not squeezed out. |
|
| Author: | Morris 1100 [ Tue Aug 04, 2009 5:52 pm ] |
| Post subject: | |
S |
|
| Author: | Mike [ Tue Aug 04, 2009 6:19 pm ] |
| Post subject: | |
l. |
|
| Author: | Mick [ Tue Aug 04, 2009 6:20 pm ] |
| Post subject: | |
What about a smear of rubber grease? Its rated for use in brake parts, and might be enough to form a seal without resorting to heavier products....or even a turn or two of good old pipe sealing teflon tape? |
|
| Author: | Morris 1100 [ Tue Aug 04, 2009 6:29 pm ] |
| Post subject: | |
Is there fluid on the top of the tank? |
|
| Author: | Mike [ Wed Aug 05, 2009 9:55 am ] |
| Post subject: | |
l. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|