No, just a light sand, Prime and off you go. It is an etch primer
| ausmini https://www.ausmini.com/forums/ |
|
| Heritage Black https://www.ausmini.com/forums/viewtopic.php?f=2&t=55838 |
Page 1 of 1 |
| Author: | Wombat [ Fri Aug 07, 2009 9:57 pm ] |
| Post subject: | Heritage Black |
I can't seem to find a definate answer anywhere. - Do you have to take the black coating off Heritage Panels before priming etc or do you just coat over the top of it? What about other brands of panels? |
|
| Author: | aaron [ Fri Aug 07, 2009 10:22 pm ] |
| Post subject: | |
No, just a light sand, Prime and off you go. It is an etch primer
|
|
| Author: | Kennomini [ Sat Aug 08, 2009 9:45 am ] |
| Post subject: | |
That would explain the new panels I've seen covered in surface rust 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|