ausmini
https://www.ausmini.com/forums/

Monotorque
https://www.ausmini.com/forums/viewtopic.php?f=2&t=56483		 Page 1 of 1
Author:  Wombat [ Fri Aug 28, 2009 8:31 am ]
Post subject:  Monotorque
Anyone have the part numbers for Monotorque head gasckets?
Author:  drmini in aust [ Fri Aug 28, 2009 8:38 am ]
Post subject: 
`ACL’ VRS gasket kit for 850/998/1098 is CP250MT.
Author:  Wombat [ Fri Aug 28, 2009 9:17 am ]
Post subject: 
and the 1275 ? and is Auto different?
Author:  drmini in aust [ Fri Aug 28, 2009 9:29 am ]
Post subject: 
1275- most people use a Payen BK450, not a monotorque.

Automatics have same head gaskets as manuals.
Author:  Wombat [ Fri Aug 28, 2009 9:32 am ]
Post subject: 
Thanks Kev- though I might stock pile a couple in view of the post about ACL in the General Forum.
Author:  drmini in aust [ Fri Aug 28, 2009 9:36 am ]
Post subject: 
Wombat wrote:
Thanks Kev- though I might stock pile a couple in view of the post about ACL in the General Forum.

I'm going to grab some ACL bearings too... while Kc etc still has stock.
Author:  Wombat [ Fri Aug 28, 2009 9:41 am ]
Post subject: 
drmini in aust wrote:
Wombat wrote:
Thanks Kev- though I might stock pile a couple in view of the post about ACL in the General Forum.

I'm going to grab some ACL bearings too... while Kc etc still has stock.


What would you recommend?
Author:  drmini in aust [ Fri Aug 28, 2009 10:28 am ]
Post subject: 
In my case, ACL Duraglide mains and big ends for my 1275S crank (-.010/-.010).
Author:  MG Rocket [ Fri Aug 28, 2009 8:47 pm ]
Post subject: 
keep buying boys... you might save 'em yet
Author:  gafmo [ Fri Aug 28, 2009 9:24 pm ]
Post subject: 
David you just saved me 1/2 hour looking for the part number 8)
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/