Couldn't see any other markings, scraped off as much of the carbon as I could.
Will visit the machinist Monday
| ausmini https://www.ausmini.com/forums/ |
|
| Bore size https://www.ausmini.com/forums/viewtopic.php?f=2&t=56497 |
Page 1 of 1 |
| Author: | MrDerrickC [ Fri Aug 28, 2009 4:26 pm ] |
| Post subject: | Bore size |
Looking to rebuild my engine but need help with identifying the bore size. Piston has AYA0090 markings on the top, engine number as is 9YA TA H35326, so a 998cc. Cheers |
|
| Author: | drmini in aust [ Fri Aug 28, 2009 4:30 pm ] |
| Post subject: | |
If no other marks (eg. 020 or 040) are stamped on the piston crown, bore should be original size, = 64.6mm. |
|
| Author: | MrDerrickC [ Fri Aug 28, 2009 4:54 pm ] |
| Post subject: | |
Couldn't see any other markings, scraped off as much of the carbon as I could. Will visit the machinist Monday
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|