| ausmini https://www.ausmini.com/forums/ |
|
| broken head stud https://www.ausmini.com/forums/viewtopic.php?f=2&t=56797 |
Page 1 of 1 |
| Author: | 72clubman [ Sun Sep 06, 2009 9:43 pm ] |
| Post subject: | broken head stud |
while tightening up the head to today which i did in order as per book, also started at 30nm then 45 nm and finally 68nm the main centre stud snapped off in the block (used the wrong stud was silver colour unlike the hardened ones which are almost black) luckily i had a set of easy outs so i got it out quite easy Can i re use my head gasket? (its was payen bk450 or something metro turbo) |
|
| Author: | simon k [ Sun Sep 06, 2009 10:34 pm ] |
| Post subject: | Re: broken head stud |
72clubman wrote: Can i re use my head gasket? (its was payen bk450 or something metro turbo)
yeah, it'll be fine |
|
| Author: | DTrain [ Sun Sep 06, 2009 10:49 pm ] |
| Post subject: | |
ken told me 30, 35, 40 then 45. i could be mistaken but u shouldnt be up anywhere near 68 |
|
| Author: | MiNi MuLiShA [ Mon Sep 07, 2009 12:10 am ] |
| Post subject: | |
DTrain wrote: ken told me 30, 35, 40 then 45. i could be mistaken but u shouldnt be up anywhere near 68
thats pound mate, which is correct.... old mates talking 68NM newton metres |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|