ausmini
https://www.ausmini.com/forums/

Don't you hate it when you don't follow your own SOP
https://www.ausmini.com/forums/viewtopic.php?f=2&t=57419		 Page 1 of 1
Author:  Wombat [ Sun Sep 27, 2009 6:18 pm ]
Post subject:  Don't you hate it when you don't follow your own SOP
Standing Operating Procedures that is. Took the fuel sender out of the tank about 3 months ago to paint the tank. Normally I would put the screws back in their holes - next choice would be leave in the vicinity of where they reside (ie in the boot in the area near the tank.) next choice would be with other nuts and bolts of similar size in the 'small bits' bins.

Be blowed if I can find the (*&^(&^$%$% things. :evil:

Anyone know what size they are?
Author:  drmini in aust [ Sun Sep 27, 2009 7:31 pm ]
Post subject: 
I can't remember the size, but..
They would be 5/32" or 3/16" dia, and UNF or UNC threads. Measure the hole with calipers... it will be obvious which diameter fits then. Then just decide if it's fine (UNF) or coarse (UNC). Buy a couple of screws to try.
Author:  gafmo [ Sun Sep 27, 2009 7:42 pm ]
Post subject: 
I'm a bad example of this also I have zip lock bags of everything but I haven't written on any of them
Author:  mini maxx [ Sun Sep 27, 2009 10:04 pm ]
Post subject: 
Zip lok bags,small bits bins? i know all my nuts and bolts are either on the car or on the garage floor, only gota look in 2 places :wink:
Author:  marc2131 [ Mon Sep 28, 2009 8:28 am ]
Post subject:  Re: Don't you hate it when you don't follow your own SOP
[quote="Be blowed if I can find the (*&^(&^$%$% things. :evil: quote]

I screw the put the screws back in but holding them in place with bits of masking tape. So far not had a problem. Also label every thing ie. passenger or driver side etc.
Author:  MG Rocket [ Mon Sep 28, 2009 10:20 am ]
Post subject: 
mini maxx wrote:
Zip lok bags,small bits bins? i know all my nuts and bolts are either on the car or on the garage floor, only gota look in 2 places :wink:

Yes.. I like to keeps my nuts in a bag and my bolt.....
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/