| ausmini https://www.ausmini.com/forums/ |
|
| Tin brake master cylinders https://www.ausmini.com/forums/viewtopic.php?f=2&t=57866 |
Page 1 of 1 |
| Author: | sports850 [ Mon Oct 12, 2009 11:22 am ] |
| Post subject: | Tin brake master cylinders |
Bit of a long story but do the internals of the earlier 0.7" master cylinder (the one without the groove around the base , also called one flat cap , one ring seal type) fit into the slightly later 0.7" master cylinder which has the groove around the base ? I have a non-grooved master cylinder to re-kit and a kit , but I also have a grooved base master cylinder that will match the clutch master cylinders shape and age . Can the internals (the whole lot including rod and spring) be swapped or are they type specific ? |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|