der Matt *smacks forhead*
thanks AWD and matty...
Ok whilst on the subject, what about blow thru, what is needed that way?
| ausmini https://www.ausmini.com/forums/ |
|
| Modifying carb for Suck Thru s/c set up? (ie. carb b4 S/C) https://www.ausmini.com/forums/viewtopic.php?f=2&t=57901 |
Page 1 of 1 |
| Author: | mattsmadmini [ Tue Oct 13, 2009 12:48 pm ] |
| Post subject: | Modifying carb for Suck Thru s/c set up? (ie. carb b4 S/C) |
Am considering going down the path of S/C small bore (998 + 100thou O/B, lightened bottom end, X pin diff etc) S/C will be a sc12.... carb will be of the HIF variety... What needs to be done to the carb to suit this type of application? |
|
| Author: | awdmoke [ Tue Oct 13, 2009 1:02 pm ] |
| Post subject: | |
Nothing. They work exactly as intended in a suck through application. |
|
| Author: | TheMiniMan [ Tue Oct 13, 2009 1:09 pm ] |
| Post subject: | |
you may find that a stronger spring is needed & obviously the correct mixture needle to suit |
|
| Author: | mattsmadmini [ Tue Oct 13, 2009 1:15 pm ] |
| Post subject: | |
der Matt *smacks forhead*
thanks AWD and matty... Ok whilst on the subject, what about blow thru, what is needed that way? |
|
| Author: | awdmoke [ Tue Oct 13, 2009 1:24 pm ] |
| Post subject: | |
A HIF turbo carb, or convert yours to have the necessary shaft seals, etc. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|