No worries, better than being headless
| ausmini https://www.ausmini.com/forums/ |
|
| Size of nuts for head studs on an 1100S 1275 https://www.ausmini.com/forums/viewtopic.php?f=2&t=57927 |
Page 1 of 1 |
| Author: | MiniMe87 [ Wed Oct 14, 2009 2:12 pm ] |
| Post subject: | Size of nuts for head studs on an 1100S 1275 |
Hi all, Got to put my head back on this weekend and was just wondering, does anyone know what the size of the nut that goes on the head studs are? I have to get a new socket and i can't remember what size the nuts are. Cheers |
|
| Author: | GT mowog [ Wed Oct 14, 2009 2:31 pm ] |
| Post subject: | |
9/16" AF |
|
| Author: | MiniMe87 [ Thu Oct 15, 2009 7:45 am ] |
| Post subject: | |
cheers GT, I have to get a socket for a torque wrench so the head can finally go back on! |
|
| Author: | GT mowog [ Thu Oct 15, 2009 12:44 pm ] |
| Post subject: | |
No worries, better than being headless
|
|
| Author: | MiniMe87 [ Thu Oct 15, 2009 1:10 pm ] |
| Post subject: | |
so i need a 9/16th socket for those nuts?? i thought they were larger then that?? |
|
| Author: | Lillee [ Thu Oct 15, 2009 1:23 pm ] |
| Post subject: | |
Can't remember the size off the top of my head but make sure you use hardenned steel washers underneath those bolts, or flanged type nuts. Don't use supercrap soft steel washers, or for that matter notthing at all! |
|
| Author: | MiniMe87 [ Thu Oct 15, 2009 1:29 pm ] |
| Post subject: | |
i can't be guarenteed of this but im pretty sure the ones that were on it were the flanged type nuts, but thanks for the heads up! |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|