Yeah,
And don't forget to tighten it properly, or the right dash card will get a little oily!!!
| ausmini https://www.ausmini.com/forums/ |
|
| Oil pressure gauge pipe question https://www.ausmini.com/forums/viewtopic.php?f=2&t=58158 |
Page 1 of 1 |
| Author: | miki [ Fri Oct 23, 2009 12:21 pm ] |
| Post subject: | Oil pressure gauge pipe question |
Is it okay to run this pipe through the bulkhead with other wires nearby? or does it get hot enough that it might compromise *melt* the electrical wires? |
|
| Author: | Tombo [ Fri Oct 23, 2009 1:05 pm ] |
| Post subject: | |
Shouldn't get hot at all as oil doesn'f flow continuously, just pushes up a bit when pressure builds then back out as pressure drops. Just make sure the pipe is insulated from the bulkhead, the last thing you want is an oil shower in the car. |
|
| Author: | miki [ Fri Oct 23, 2009 1:57 pm ] |
| Post subject: | |
thanks mate. |
|
| Author: | BBY755 [ Fri Oct 23, 2009 2:20 pm ] |
| Post subject: | |
Yeah, And don't forget to tighten it properly, or the right dash card will get a little oily!!!
|
|
| Author: | DTrain [ Sat Oct 24, 2009 12:10 am ] |
| Post subject: | |
and dont unwind the whole copper pipe, leave it wound and it will absorb most of the bumps and knocks |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|