Not fall out like that - but I had to dig out quite a lot from the clutch end rear side of the block - and between 3 and 4 - no wonder the PO had an overheating problem
| ausmini https://www.ausmini.com/forums/ |
|
| Casting Sand https://www.ausmini.com/forums/viewtopic.php?f=2&t=58519 |
Page 1 of 1 |
| Author: | Blokeinamoke [ Thu Nov 05, 2009 5:04 pm ] |
| Post subject: | Casting Sand |
Anybody else found a solid chunk of casting sand floating around your sump? This lump was about the size 50 cent piece and about 1 cm high. You think after nearly 40 years it would have fallen off before now. I had the sump off last year and all was well. I pulled the gb housing/sump off because something was blocking oil plug so it wouldnt drain correctly and there it was wedged again the side. |
|
| Author: | Wombat [ Thu Nov 05, 2009 5:12 pm ] |
| Post subject: | |
Not fall out like that - but I had to dig out quite a lot from the clutch end rear side of the block - and between 3 and 4 - no wonder the PO had an overheating problem
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|