| ausmini https://www.ausmini.com/forums/ |
|
| Bonnet Channel Rubber https://www.ausmini.com/forums/viewtopic.php?f=2&t=58831 |
Page 1 of 1 |
| Author: | ryan [ Tue Nov 17, 2009 9:42 am ] |
| Post subject: | Bonnet Channel Rubber |
Hi all. My car doesn't have the rubber that sits in the channel across the back of the engine bay, where the bonnet sits. Can these be bought new? can I just go into clarke rubber and get something? what size is it? Regards |
|
| Author: | AEG163job [ Tue Nov 17, 2009 11:12 am ] |
| Post subject: | |
Part No HYA3925. Clark Rubber could be the go, but remember it needs to be soft & compressable. I'm not sure the seal is all that effective, as every wiper motor I've ever disasembled has always had water damage. Maybe it's purpose is to prevent the bonnet rattling. |
|
| Author: | Fat Boy Dave [ Tue Nov 17, 2009 11:40 am ] |
| Post subject: | |
Nice profile pic, like the Polka dot dress. |
|
| Author: | Babes [ Tue Nov 17, 2009 1:38 pm ] |
| Post subject: | |
yes they can be bought new, think i got mine from minisport SA |
|
| Author: | Morris 1100 [ Tue Nov 17, 2009 4:42 pm ] |
| Post subject: | |
There was two different types for the roundie and the clubbie. |
|
| Author: | drmini in aust [ Tue Nov 17, 2009 7:26 pm ] |
| Post subject: | |
I got the roundy one (sponge) from Grippy Rubber in Silverwater. 1M is enough, trim it to fit. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|