Yes
| ausmini https://www.ausmini.com/forums/ |
|
| A+ diff ratios https://www.ausmini.com/forums/viewtopic.php?f=2&t=58845 |
Page 1 of 1 |
| Author: | kiwiinwgtn [ Tue Nov 17, 2009 6:25 pm ] |
| Post subject: | A+ diff ratios |
Hi Will an A+ crown and pinion fit a non a plus box (rod change) Ta Kiwiinwgtn |
|
| Author: | drmini in aust [ Tue Nov 17, 2009 6:31 pm ] |
| Post subject: | |
Yes. The only problem you will have with the taller ratios is the bigger diameter pinion will foul inside the bearing retainer. Simply put the retainer in a lathe and bore it out to clear. |
|
| Author: | 850man [ Tue Nov 17, 2009 6:31 pm ] |
| Post subject: | |
Yes
|
|
| Author: | kiwiinwgtn [ Tue Nov 17, 2009 6:38 pm ] |
| Post subject: | |
Hi Kev Not sure what you mean by bearing retainer Ta Kiwiinwgtn |
|
| Author: | drmini in aust [ Tue Nov 17, 2009 6:41 pm ] |
| Post subject: | |
The big cast steel thing (3 or 4 bolts) that holds the mainshaft bearing in... it's behind/around the diff pinion. It clears a 3.44 pinion, maybe a 3.2, any taller ratio and you'll have to bore it out slightly. |
|
| Author: | kiwiinwgtn [ Tue Nov 17, 2009 6:57 pm ] |
| Post subject: | |
Thanks Now to find one 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|