In the pic these selectors have been modified what do you think has been done
| ausmini https://www.ausmini.com/forums/ |
|
| Rod change selectors mods (updated) https://www.ausmini.com/forums/viewtopic.php?f=2&t=59095 |
Page 1 of 1 |
| Author: | kiwiinwgtn [ Thu Nov 26, 2009 6:39 pm ] |
| Post subject: | Rod change selectors mods (updated) |
In the pic these selectors have been modified what do you think has been done
|
|
| Author: | encho [ Thu Nov 26, 2009 6:54 pm ] |
| Post subject: | |
not seen them before but it looks like they have been made thinner and wedged |
|
| Author: | Asphalt [ Thu Nov 26, 2009 7:23 pm ] |
| Post subject: | |
This is the std. rod: http://img209.imageshack.us/img209/3032 ... hifter.jpg 
Looks like he wedged the selector pin and enhanced the wedging of the fork shifter things (don't know the name). |
|
| Author: | Morris 1100 [ Thu Nov 26, 2009 7:30 pm ] |
| Post subject: | |
I would almost bet that one of the selectors is offset to the other one slightly.
If you do it properly you can't easily move the gearstick side to side in neutral. You have to wiggle it to go sideways! 1st to 2nd = normal 2nd to 3rd = easier 3rd to 4th = normal 4th to 1st = almost impossible. |
|
| Author: | kiwiinwgtn [ Fri Nov 27, 2009 7:51 pm ] |
| Post subject: | |
A better picture http://cgi.ebay.co.uk/Genuine-ACDodd-Sl ... 439a296734 |
|
| Author: | kiwiinwgtn [ Sat Nov 28, 2009 5:19 pm ] |
| Post subject: | |
ok This is what i think is happening They have weld the tongue to the shaft They have chamfered the tongue (looks like both sides) They have re chamfered both selector rods What I think is happening is the shaft has to rotate less to clear the selector so making the travel of the gear stick less between 2nd and third making quicker and smoother gear changes What do you think Kiwiinwgtn |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|
