| ausmini https://www.ausmini.com/forums/ |
|
| Bolt Thread size? tacho wire? https://www.ausmini.com/forums/viewtopic.php?f=2&t=59589 |
Page 1 of 1 |
| Author: | ryan [ Mon Dec 14, 2009 8:20 pm ] |
| Post subject: | Bolt Thread size? tacho wire? |
What size are the bolts that hold the clutch slave cylinder on? Also, what side of the coil does the tacho wire go to? is it '-' ? |
|
| Author: | drmini in aust [ Mon Dec 14, 2009 8:26 pm ] |
| Post subject: | |
3/8 UNC. tacho wire goes to the `-' terminal. |
|
| Author: | ryan [ Mon Dec 14, 2009 8:26 pm ] |
| Post subject: | |
thanks doc! |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|