Mini CV ones are 9/16", but pot joints have bigger balls.
You can get standard imperial size ones from bearing shops. They are pretty cheap.
| ausmini https://www.ausmini.com/forums/ |
|
| CV ball bearing size? https://www.ausmini.com/forums/viewtopic.php?f=2&t=60497 |
Page 1 of 1 |
| Author: | Monaco [ Thu Jan 21, 2010 8:33 pm ] |
| Post subject: | CV ball bearing size? |
Hi, Can anyone tell me what size they are and where I can get a set from? Thanks! |
|
| Author: | Aussie Brian [ Thu Jan 21, 2010 8:40 pm ] |
| Post subject: | |
I was told 9/16ths but some one else may confirm. |
|
| Author: | justminis [ Thu Jan 21, 2010 8:53 pm ] |
| Post subject: | |
and are they the same size for the 2? different types of pot joints? |
|
| Author: | drmini in aust [ Thu Jan 21, 2010 9:12 pm ] |
| Post subject: | |
Mini CV ones are 9/16", but pot joints have bigger balls.
You can get standard imperial size ones from bearing shops. They are pretty cheap. |
|
| Author: | mtsmini [ Thu Jan 21, 2010 9:54 pm ] |
| Post subject: | Ball bearings |
Minisport in Adelaide has them: http://www.minisport.com.au/prod506.htm Other shops probably have as well. |
|
| Author: | Gareth_1330 [ Fri Jan 22, 2010 6:59 am ] |
| Post subject: | |
21/32nds for pot joints... i ordered some from CBC, and they were packed as 21/32, but in actual fact they were 23/32, so watch out |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|