Two words:
David Rosenthal
| ausmini https://www.ausmini.com/forums/ |
|
| Getting an Intake manifold made https://www.ausmini.com/forums/viewtopic.php?f=2&t=61605 |
Page 1 of 1 |
| Author: | mattsmadmini [ Mon Mar 08, 2010 4:30 pm ] |
| Post subject: | Getting an Intake manifold made |
As title suggests... what is the easiest way to get an intake manifold made for a pair of motorbike carbs? (15* not like an SU's 30*) An S shaped manifold is what im thinkin... would an exhaust shop knock one up or do i go somewhere more specialist? |
|
| Author: | sgc [ Mon Mar 08, 2010 5:18 pm ] |
| Post subject: | |
Two words: David Rosenthal
|
|
| Author: | drmini in aust [ Mon Mar 08, 2010 5:25 pm ] |
| Post subject: | Re: Getting an Intake manifold made |
mattsmadmini wrote: As title suggests... what is the easiest way to get an intake manifold made for a pair of motorbike carbs? (15* not like an SU's 30*)
An S shaped manifold is what im thinkin... would an exhaust shop knock one up or do i go somewhere more specialist? I made a 15° one years ago for twin Amal Monobloc bike carbs. I used hollow steel bar and machined the bore out to what I needed. No need to bend it, just cut each end to 7.5° and weld flanges on. 
|
|
| Author: | mattsmadmini [ Mon Mar 08, 2010 5:41 pm ] |
| Post subject: | |
If i were to fab those up Kev would you be my welder?
pretty please!!! |
|
| Author: | drmini in aust [ Mon Mar 08, 2010 5:43 pm ] |
| Post subject: | |
Sure.
call me on MSN. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|