I fitted a Pulsar dizzy to a 1098, then later modified it for a 1275A+. Bushed the 3/16" shaft hole and slid the A+ dog on. Only other mod was to file a casting fin away so the A+ clamp fork would fit.
Too easy.
| ausmini https://www.ausmini.com/forums/ |
|
| Fitting Standard A series Distributor in an A + https://www.ausmini.com/forums/viewtopic.php?f=2&t=61609 |
Page 1 of 1 |
| Author: | Convertible Mini [ Mon Mar 08, 2010 5:58 pm ] |
| Post subject: | Fitting Standard A series Distributor in an A + |
I have mastered the art of modifying an A series dizzy to fit in an A+. I have had all the necessary Drive dogs made up and know what needs to be machined. My experimental one was a 29D4. works well on an A+ now and even fitted it with electronic Kit. |
|
| Author: | GT mowog [ Mon Mar 08, 2010 6:05 pm ] |
| Post subject: | |
Hey, that's cool, but be sure to shorten the dissy shaft a tad, usually 30 thou get the job done. Cheers |
|
| Author: | TheMiniMan [ Mon Mar 08, 2010 8:47 pm ] |
| Post subject: | |
Years ago (Maybe 15-ish years ago, when i was working for Macs Minis) we did many conversions for both directions,,, A-series dizzy into A+ donk ...& A+ dizzy into A-series donk easy-peasy & there are quite a few different ways to achieve both results |
|
| Author: | drmini in aust [ Mon Mar 08, 2010 9:13 pm ] |
| Post subject: | |
I fitted a Pulsar dizzy to a 1098, then later modified it for a 1275A+. Bushed the 3/16" shaft hole and slid the A+ dog on. Only other mod was to file a casting fin away so the A+ clamp fork would fit. Too easy.
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|