The diametre of the hole on the side that bolts to the manifold, not the air filter side.
| ausmini https://www.ausmini.com/forums/ |
|
| HIF Carb https://www.ausmini.com/forums/viewtopic.php?f=2&t=6161 |
Page 1 of 1 |
| Author: | redfive [ Thu Apr 07, 2005 11:24 am ] |
| Post subject: | HIF Carb |
Which bit of the carb do I measure to determine its size? |
|
| Author: | Boostedmini [ Thu Apr 07, 2005 11:42 am ] |
| Post subject: | |
the bore of the carb being where the air passes through |
|
| Author: | poeee [ Thu Apr 07, 2005 12:18 pm ] |
| Post subject: | |
The diametre of the hole on the side that bolts to the manifold, not the air filter side.
|
|
| Author: | redfive [ Thu Apr 07, 2005 2:25 pm ] |
| Post subject: | |
Typical. Spose I better take the manifold off then and check it. |
|
| Author: | gafmo [ Thu Apr 07, 2005 5:12 pm ] |
| Post subject: | |
1 1/5 have one bolt on top and HIF44 have all four with no exposed float bowl as it under the card 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|