ausmini https://www.ausmini.com/forums/ |
|
Rubber washer & steering rack https://www.ausmini.com/forums/viewtopic.php?f=2&t=61620 |
Page 1 of 1 |
Author: | andyd718 [ Mon Mar 08, 2010 9:58 pm ] |
Post subject: | Rubber washer & steering rack |
Does anyone know if there is supposed to be a rubber washer/seal that goes between the steering rack and the shell? I can't remember there being one but it looks like something's supposed to be there... |
Author: | TheMiniMan [ Mon Mar 08, 2010 10:59 pm ] |
Post subject: | |
it was a felt originally |
Author: | AEG163job [ Mon Mar 08, 2010 11:06 pm ] |
Post subject: | |
Damn hard to find in parts books. Basically, its flat spongey round seal about 1 1/2" in diameter which stops the dirt & water entering. If you can get hold of some soft spongey rubber about 5 mm thick so it compresses when you bolt up the rack, that should do the trick. |
Author: | TheMiniMan [ Mon Mar 08, 2010 11:09 pm ] |
Post subject: | |
cut up an old thong No,,, not "That" type of thong you dirty old men ![]() |
Author: | GT mowog [ Tue Mar 09, 2010 5:49 am ] |
Post subject: | |
AEG163job wrote: Damn hard to find in parts books. Basically, its flat spongey round seal about 1 1/2" in diameter which stops the dirt & water entering. If you can get hold of some soft spongey rubber about 5 mm thick so it compresses when you bolt up the rack, that should do the trick.
P/N 21A30, should cost you all of about $1.50. They are 12mm thick when new and a soft foam rubber, but when they're squashed they don't come back. If you make one from a thong, don't cut the centre hole too small, you don't want that tight at all. Oh and panties are way better than thongs.................. |
Author: | EST-071 [ Tue Mar 09, 2010 8:08 pm ] |
Post subject: | |
Last time I replaced one I used an old mouse pad and cut one to fit. Cheers Pete |
Author: | micowen [ Tue Mar 09, 2010 8:24 pm ] |
Post subject: | |
doogie once mentioned that he uses the bottom off a stubby cooler! Every blokes got a collection of them laying around! ![]() |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |