| ausmini https://www.ausmini.com/forums/ |
|
| Cv questions https://www.ausmini.com/forums/viewtopic.php?f=2&t=62109 |
Page 1 of 1 |
| Author: | blue_deluxe [ Tue Mar 30, 2010 12:36 pm ] |
| Post subject: | Cv questions |
I'm swapping my rubber uni joints over to pot joints and I've run into a few problems. Is there meant to be a circlip holding the pot joint to the diff ouput shaft? Is the driveshaft just resting in the outer cv or is there a circlip there? I need to reuse my cvs so don't want to have to hammer them off the old shafts. Cheers, Joe |
|
| Author: | TheMiniMan [ Tue Mar 30, 2010 2:09 pm ] |
| Post subject: | |
Yes Joe, circlips on both the inner axle for the pot joints,,, & the outer end of the main axle for the outer cv joints to clip onto as well |
|
| Author: | blue_deluxe [ Tue Mar 30, 2010 3:27 pm ] |
| Post subject: | |
Thanks Matt, I did manage to get the outer cv ones on and I'm pretty sure I invented a few new swear words. Going to go back later to do the inner joints. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|