The water that enters the cyl from the blown head gasket acts as (sort of like) a steam cleaner
so middle cyls clean-ish from the steam cleaner,,,outer 2 cyls typically black & sooted up from normal poor mixture , bad tune & crap fuel
| ausmini https://www.ausmini.com/forums/ |
|
| Piston Gunk https://www.ausmini.com/forums/viewtopic.php?f=2&t=62190 |
Page 1 of 1 |
| Author: | Drexxle [ Fri Apr 02, 2010 7:20 pm ] |
| Post subject: | Piston Gunk |
So i did a head gasket today. And i noticed that the 2&3 pistons sprayed with degreaser were easy to wipe clean. 1&4 however were crunchy black, but not covering all of the piston, more black to the outsides than towards 2&3. Any ideas as to why. |
|
| Author: | TheMiniMan [ Fri Apr 02, 2010 7:30 pm ] |
| Post subject: | |
The water that enters the cyl from the blown head gasket acts as (sort of like) a steam cleaner so middle cyls clean-ish from the steam cleaner,,,outer 2 cyls typically black & sooted up from normal poor mixture , bad tune & crap fuel
|
|
| Author: | Drexxle [ Fri Apr 02, 2010 7:37 pm ] |
| Post subject: | |
I think crap fuel is right, stupid OPAL unleaded. And even the 95 here in Alice seems to be crap. That window also goes in tomorrow Matt, crappy rubbers on the one you gave me, and pain to take the whole door apart to replace it. Probably take half the day just to do that. |
|
| Author: | TheMiniMan [ Fri Apr 02, 2010 7:38 pm ] |
| Post subject: | |
Ah,,, see now that`s where the metho comes into the picture
Gotasmoke mate??? |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|