| ausmini https://www.ausmini.com/forums/ |
|
| pushrods https://www.ausmini.com/forums/viewtopic.php?f=2&t=63548 |
Page 1 of 1 |
| Author: | kiwiinwgtn [ Sun Jun 06, 2010 9:08 pm ] |
| Post subject: | pushrods |
I was reading the April Mini Mag and i noticed that they are are remanufactoring pushrods for the 1275 engine. My question is are the push rods from a injected Mini different to in design than say early OZ / Kiwi cars The ones shown come a part so they could be easy shortned to correct rocker geometry comments Kiwiinwgtn 
|
|
| Author: | doogie [ Sun Jun 06, 2010 9:15 pm ] |
| Post subject: | |
850/998/1100 pushrods are shorter than 1275 pushrods, as far as i know all 1275 pushrods are the same. Doogie |
|
| Author: | drmini in aust [ Sun Jun 06, 2010 9:20 pm ] |
| Post subject: | |
Woops, I better go buy a few sets of NOS 1275 pushrods while I still can. 
|
|
| Author: | simon k [ Sun Jun 06, 2010 9:25 pm ] |
| Post subject: | |
I was gonna say, Karcraft lists them for $10 each... |
|
| Author: | Convertible Mini [ Mon Jun 07, 2010 6:07 am ] |
| Post subject: | Push rods |
I have bucket loads of S/H push rods both long and short. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|