ausmini
https://www.ausmini.com/forums/

nut and bolt job
https://www.ausmini.com/forums/viewtopic.php?f=2&t=63749
Page 1 of 1

Author:  estapol [ Tue Jun 15, 2010 3:32 pm ]
Post subject:  nut and bolt job

Hi people

I've stripped my clubman to its shell and found alot of crappy nuts bolts
and screws.
I want to replace the whole car with new fasteners.
Does anyone have a rough list of whats in the clubman s or am I gonna have to go through with thread measurers and find out the size and thread of all of them????
[/quote]

Author:  Mick [ Tue Jun 15, 2010 3:35 pm ]
Post subject: 

http://www.ausmini.com/forums/viewtopic ... light=nuts

There's a list there of the engine bolts which should help. I realise you will need an extra supply of nuts and bolts for the rest of the car however.

Author:  estapol [ Tue Jun 15, 2010 3:43 pm ]
Post subject: 

yeah cheers mick
I'm getting a recon'd engine and box anyway
but cheers ill keep that for future reference

Author:  TheBlackMini [ Tue Jun 15, 2010 4:42 pm ]
Post subject: 

I've run in to the same problem. A lot of my nuts and bolts are either very rusty or stripped or the head has been stripped badly.

Just looked through Mini King catalog, Haynes Resto manual and service manual. No mention of sizes.

Looks, like it'll be individually sized up and ordered. :cry:

Author:  '77 clubby van [ Tue Jun 15, 2010 7:22 pm ]
Post subject: 

A good place to start is with a heap of high tensile 1/4"unf bolts. 3/4" long would probably take care of a lot of the body bolts.

Or just take a bucket of the rusty stuff down to the local bolt place and get them to help. :wink:

Author:  Moriarty [ Tue Jun 15, 2010 8:52 pm ]
Post subject: 

Looks like it's time to develop something for the Ausmini reference section. :wink: *cough cough*

Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/