What are peoples thoughts on this nice piece of engineering?

Nice, but too expensive for what it is.
I'm still looking for some light quality uni joints to make my own.

_________________
Too many cars, and too little time.

Short shifter is much better value for the money in my opinion, much easier to install too as it doesn't need part of the floor cut out.

Really, what are they thinking trying to get $600 for a couple of brackets and universal joints?

Would $250 be a more appropriate price?

the only really tricky bit is that one of the U/J's has a left hand thread in it. apart from that it is all standard stuff, nicely made mind you.

_________________
the world is a book, and those who do not travel read only a page
66 Mini Minor sponsored by http://www.lifeonthehedge.com.au/ The Dog Harness Specialists
It was a pleasure ausmini. I'll miss all you misfits and reprobates

willy, if you're still tring to sell yours just slap it up on ebay already and see what people will pay. If you're prepared to post internationally you could get more than what you've been asking.

Good point, i'll pop it up there later on in the week.