ausmini
https://www.ausmini.com/forums/

Cam Bearing Press?
https://www.ausmini.com/forums/viewtopic.php?f=2&t=63879		 Page 1 of 1
Author:  1310S [ Mon Jun 21, 2010 10:00 am ]
Post subject:  Cam Bearing Press?
Does anyone have photos or drawings of a cam bearing press?
Author:  justminis [ Mon Jun 21, 2010 6:19 pm ]
Post subject: 
Is this what you are looking for?

Go to "How To", then "Install Cam Bearings"

http://www.aptfast.com/
Author:  mini-dunger [ Mon Jun 21, 2010 9:50 pm ]
Post subject: 
thanks for that link... Having a lathe and all I can make that
Author:  simon k [ Mon Jun 21, 2010 10:09 pm ]
Post subject: 
mini-dunger wrote:
thanks for that link... Having a lathe and all I can make that


too easy !
Author:  mini_mad_matt [ Mon Jun 21, 2010 10:37 pm ]
Post subject: 
Make sure when you put the bearings in you line up the holes with the oil galleries :D
Author:  1310S [ Tue Jun 22, 2010 10:00 am ]
Post subject: 
Thanks, That's just what I wanted.
Cheers
Author:  drmini in aust [ Tue Jun 22, 2010 5:37 pm ]
Post subject: 
mini_mad_matt wrote:
Make sure when you put the bearings in you line up the holes with the oil galleries :D

And be careful with the front one- check the old bearing's various hole positions before you push it out.
Author:  mickmini [ Tue Jun 22, 2010 9:05 pm ]
Post subject: 
drmini in aust wrote:
mini_mad_matt wrote:
Make sure when you put the bearings in you line up the holes with the oil galleries :D

And be careful with the front one- check the old bearing's various hole positions before you push it out.


got pics showing a correct one?
Author:  drmini in aust [ Tue Jun 22, 2010 10:10 pm ]
Post subject: 
Sorry no I don't, nor do I have a block (with the bearing in) handy right now.
But if you get it wrong (backwards?) you can get full pressure feed to the rocker gear, not the correct intermittent pulses from the axial groove on the cam journal.
Author:  1310S [ Tue Jun 22, 2010 10:59 pm ]
Post subject: 
Been there! Local machine shop put the bearing in the wrong way, it was fine until you held constant high revs for a length of time, then I had oil comming out the rocker cover and filling the catch tank.
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/