Finally got the seats in! They are a lot less 'huggy' than the sparcos but are much more comfortable and look great!
| ausmini https://www.ausmini.com/forums/ |
|
| MX5 Seats - Success!! https://www.ausmini.com/forums/viewtopic.php?f=2&t=63995 |
Page 1 of 1 |
| Author: | Mike Montgomery [ Sat Jun 26, 2010 5:25 pm ] |
| Post subject: | MX5 Seats - Success!! |
Finally got the seats in! They are a lot less 'huggy' than the sparcos but are much more comfortable and look great!
|
|
| Author: | adamstuart [ Sat Jun 26, 2010 5:26 pm ] |
| Post subject: | |
How difficult were they to put in? Looks like you just bolted them through the pre-existing hole and away you go? |
|
| Author: | Mike Montgomery [ Sat Jun 26, 2010 5:41 pm ] |
| Post subject: | |
they were hard actually... Had to heat the rails and bend the bolt hole flat front and back. I ran a steel bar between the two rear bolt hole which also propped the back up to a level height. had to drill new holes for the front. |
|
| Author: | junior [ Sat Jun 26, 2010 9:26 pm ] |
| Post subject: | |
Nice work Mike, that's another thing ticked off the list. Did you have them re-trimmed to suit? |
|
| Author: | dodge [ Sun Jun 27, 2010 10:08 am ] |
| Post subject: | |
can you show me a pic of them folded forward |
|
| Author: | Mike Montgomery [ Sun Jun 27, 2010 5:18 pm ] |
| Post subject: | |
I'll get a picture of them folded forward tomorrow.. They were custom upholstered for the MX5 they came out of which was rapped around a pole and they just happened to be black and red 
|
|
| Author: | dodge [ Sun Jun 27, 2010 8:18 pm ] |
| Post subject: | |
cheers , just want to see them slid forward and folded so i can see if i can still get bodies in the back without having them attempt yoga |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|