| ausmini https://www.ausmini.com/forums/ |
|
| Dressy Rad Shrould bolts/screws https://www.ausmini.com/forums/viewtopic.php?f=2&t=64082 |
Page 1 of 1 |
| Author: | Hanra [ Wed Jun 30, 2010 1:02 pm ] |
| Post subject: | Dressy Rad Shrould bolts/screws |
What have people used to attach there radiator shrouds to the rad? Ive currently got some very small/short coarse threaded bolts that have had the heads powder coated. Was hoping to use something stainless perhaps? |
|
| Author: | 1018cc [ Wed Jun 30, 2010 2:48 pm ] |
| Post subject: | |
If you buy one of those chinese radiators off of ebay you get a M6x1.0 thread. I used stainless steel allen key headed bolts to hold the shroud on then. That is unless you specifically want to keep your radiator? |
|
| Author: | Hanra [ Wed Jun 30, 2010 3:02 pm ] |
| Post subject: | |
Yeah im not intending on changin rads, mine was re-tanked and two pak'd years ago. Its still in good nick. |
|
| Author: | Mick [ Wed Jun 30, 2010 3:02 pm ] |
| Post subject: | |
The original style are still available new in bright zinc plating, not as flash as stainless or chrome plated but better than rusty I suppose... http://www.minispares.com/Product.aspx? ... 033&title= |
|
| Author: | Hanra [ Wed Jun 30, 2010 3:48 pm ] |
| Post subject: | |
Ayyy thats the ones that Ive got! |
|
| Author: | GT mowog [ Wed Jun 30, 2010 4:01 pm ] |
| Post subject: | |
Personally I don't like putting Stainless Steel Screws against plain Steel. It does cause the steel to rust lile crazy unless the paint and / or insulating washers are in good nick. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|