| ausmini https://www.ausmini.com/forums/ |
|
| Radum Blasting Cabinet - Compressor https://www.ausmini.com/forums/viewtopic.php?f=2&t=64135 |
Page 1 of 1 |
| Author: | Monaco [ Thu Jul 01, 2010 11:37 pm ] |
| Post subject: | Radum Blasting Cabinet - Compressor |
Hi all, How much cfm or litres per min flow do I need to run a radum blasting cabinet? |
|
| Author: | GT mowog [ Fri Jul 02, 2010 7:08 am ] |
| Post subject: | |
LOTS. Probably the minimum would be 22 cfm, but as always, the bigger the better... |
|
| Author: | justminis [ Fri Jul 02, 2010 9:09 am ] |
| Post subject: | |
Agree with GTM. Be aware that some shops rely upon different pressures when they quote their "Free Air Delivery" figures. For some, their figures are based on 90psi, which gives a higher FAD figure than those who use the 100psi rating. So ask before you buy. I pick up my 3 phase 7.5HP mother tomorrow morning  . Looking forward to having that much "air" available
|
|
| Author: | Kennomini [ Fri Jul 02, 2010 10:19 pm ] |
| Post subject: | |
WATER TRAPS  get water traps. If you get moisture coming through your media blasting set up it can quickly clog up, very annoying 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|