The curvature of a roundy bonnet may make them look a bit
.
Very neat looking design though. Maybe a bit modern for a 60's or 70's car?
| ausmini https://www.ausmini.com/forums/ |
|
| Aerocatch Bonnet Fasteners https://www.ausmini.com/forums/viewtopic.php?f=2&t=64272 |
Page 1 of 1 |
| Author: | slide [ Fri Jul 09, 2010 8:40 am ] |
| Post subject: | Aerocatch Bonnet Fasteners |
Anyone fitted these as an alternative to bonnet pins? They fit flush with the bonnet and can be locked with a key if wanted, Merlin Motorsport sells them cheaper than most other suppliers. www.AeroCatch.com |
|
| Author: | subwayseth [ Fri Jul 09, 2010 9:05 am ] |
| Post subject: | |
they look a lot bigger (126mm long). kind of reminds me of those locks on the side of a computer case....if your after locking pins a bit smaller these could be your answerhttp://www.statracing.com/images/store/mrg-1472.jpg. Also come in a carbon look http://www.speedzonemotorsports.com/images/P/image.php-01.jpg |
|
| Author: | Molina [ Fri Jul 09, 2010 12:19 pm ] |
| Post subject: | |
The curvature of a roundy bonnet may make them look a bit .
Very neat looking design though. Maybe a bit modern for a 60's or 70's car? |
|
| Author: | superSeven [ Fri Jul 09, 2010 4:14 pm ] |
| Post subject: | |
d-zuz fasteners |
|
| Author: | Mokesta [ Fri Jul 09, 2010 7:38 pm ] |
| Post subject: | |
Looks like an expensive adaptation of truck body locks: http://www.uesint.com/upload/pdf/C2%20Latches.pdf or http://www.uesint.com/upload/pdf/C5%20Latches.pdf The UES wed site is a bit crap but they do have lots of good gear. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|