| ausmini https://www.ausmini.com/forums/ |
|
| engine size ? https://www.ausmini.com/forums/viewtopic.php?f=2&t=64359 |
Page 1 of 1 |
| Author: | tassie55 [ Mon Jul 12, 2010 7:20 pm ] |
| Post subject: | engine size ? |
can someone tell me if i'm right with this before buying engine parts please Engine no.99h834ajh7154 Head no.12g202 is it a 998 and is the head compatable with this block?i was going to put 1100 out of morris 1100 in it but after pulling it apart yesterday it doesn't seem such a big job to rebuild it.They are not as complicated as they look(motor/gearbox together)can't be any harder than building my 6cyl ford race engines a few years back. Thanks |
|
| Author: | drmini in aust [ Mon Jul 12, 2010 7:24 pm ] |
| Post subject: | |
Yes it is (or maybe was) a 998. But many have had a 1098 crank and pistons put in during rebuilds, so measure the stroke while the head is off. 998 = 76.2mm 1098 = 83.7mm. Your 202 head will work fine, but if it is a 998 it's best to deck the head by 1.0-1.5mm or C/R will be a bit low. |
|
| Author: | tassie55 [ Mon Jul 12, 2010 8:09 pm ] |
| Post subject: | |
thanks i wasn't sure what it was supposed to be so i thought it better to ask than assume it was ok |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|