ausmini
https://www.ausmini.com/forums/

part no;
https://www.ausmini.com/forums/viewtopic.php?f=2&t=64596		 Page 1 of 1
Author:  jimmyinamini [ Sat Jul 24, 2010 10:55 am ]
Post subject:  part no;
any one got a part no for a head gasket for a 1100

cheers
Author:  drmini in aust [ Sat Jul 24, 2010 12:38 pm ]
Post subject: 
`ACL’ VRS MONOTORQUE GASKET KIT FOR 998/1098 IS P/NO CP250MT.
I'm not sure of ACL's gasket alone p/no.

This gasket alone is also available from Karcraft under p/no AJM302EVA <B2> for $19 approx. (my 2009 catalog)

Note ACL don't list 1098 on the packaging... :roll:
Author:  850 GT [ Sat Jul 24, 2010 1:27 pm ]
Post subject: 
Just looked in ACL book, dose not list gasket alone!
book is a few years old.
Author:  jimmyinamini [ Sat Jul 24, 2010 1:35 pm ]
Post subject: 
thats ok i will need whole gasket set

cheers
Author:  drmini in aust [ Sat Jul 24, 2010 1:49 pm ]
Post subject: 
You can get other gaskets, however these ACLs are the only ones that seem to hold up with a turbo on. They are a good gasket (but PLEASE, retorque them hot- don't believe that Monotorque blurb). :lol:
Author:  jimmyinamini [ Sat Jul 24, 2010 5:52 pm ]
Post subject: 
no prob thanx for the info i will remember to retorque them hot :D
Author:  jester99 [ Sat Jul 24, 2010 6:19 pm ]
Post subject: 
bought one just recently, the composite competition version to suit 1098 mini including large overbores, part number AP250MT, head gasket only.

8)
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/