simon k wrote:
might have been your fault James ... did you put it in by locking 2 nuts together on it and screwing it in?
it wasnt my fault if you dont have anything nice to say simon dont say any thing at all 
| ausmini https://www.ausmini.com/forums/ |
|
| torque rocker gear https://www.ausmini.com/forums/viewtopic.php?f=2&t=64718 |
Page 1 of 1 |
| Author: | jimmyinamini [ Thu Jul 29, 2010 7:59 pm ] |
| Post subject: | torque rocker gear |
anyone know the requred torque for the small nuts cheers |
|
| Author: | GT mowog [ Thu Jul 29, 2010 8:14 pm ] |
| Post subject: | Re: torque rocker gear |
jimmyinamini wrote: anyone know the requred torque for the small nuts
cheers Factory figures say 25 ft/lbs however IMO too tight. 18 ft/lb would be quite satisfactory. |
|
| Author: | jimmyinamini [ Thu Jul 29, 2010 8:23 pm ] |
| Post subject: | |
good to hear that it wasent me fault that the thread striped |
|
| Author: | simon k [ Thu Jul 29, 2010 9:39 pm ] |
| Post subject: | |
might have been your fault James ... did you put it in by locking 2 nuts together on it and screwing it in? |
|
| Author: | jimmyinamini [ Thu Jul 29, 2010 9:46 pm ] |
| Post subject: | |
simon k wrote: might have been your fault James ... did you put it in by locking 2 nuts together on it and screwing it in? it wasnt my fault if you dont have anything nice to say simon dont say any thing at all
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|