| ausmini https://www.ausmini.com/forums/ |
|
| Where does the temp sender go? https://www.ausmini.com/forums/viewtopic.php?f=2&t=64769 |
Page 1 of 1 |
| Author: | jme [ Sun Aug 01, 2010 7:18 pm ] |
| Post subject: | Where does the temp sender go? |
As the subject says, where abouts does the temp sender go? Also, what colour wire goes to it? |
|
| Author: | Mick [ Sun Aug 01, 2010 9:08 pm ] |
| Post subject: | |
The temp sender connects directly to the back of your temperature gauge (if you have a early instrument cluster) with 10 volts via a regulator connecting to the other terminal on the gauge. If you have a clubman it goes to the instrument panel plug at the back of the gauge cluster and onto the flexible PCB. Green/Blue is the colour of the roundnose wires connecting the gauge to the sender. I have no idea what colour the clubman type is. |
|
| Author: | GT mowog [ Sun Aug 01, 2010 9:17 pm ] |
| Post subject: | |
Mick wrote: Green/Blue is the colour of the roundnose wires connecting the gauge to the sender. I have no idea what colour the clubman type is.
Same on clubbie. |
|
| Author: | 850man [ Sun Aug 01, 2010 10:30 pm ] |
| Post subject: | |
The temp sender screws into a hole in the cylinder head below the thermostat housing, just above the engine number pad. If your cylinder head does not have this hole then the sender was fitted into a special thermostat housing made for the job. You can still buy them new, Aust castings make them, available from Bursons. Heres a pic of an old one I use when I am painting my engines... 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|