| ausmini https://www.ausmini.com/forums/ |
|
| Wiring up a Tacho - Electronic Buffs https://www.ausmini.com/forums/viewtopic.php?f=2&t=65535 |
Page 1 of 1 |
| Author: | junior [ Wed Sep 08, 2010 4:17 pm ] |
| Post subject: | Wiring up a Tacho - Electronic Buffs |
Just got a Omori Tacho, problem being it has no wiring diagram other than a red & white dot next to two of the 4 terminals, I would assume that this is +ve & -ve. Not even sure if it is to suit a 4,6,8 cylinder etc. What's the safest way to test it without destroying it? Any ideas on what the extra two terminals are? I don't think the hole in the case is for a light as it did have a rubber blanking grommet 
|
|
| Author: | winabbey [ Wed Sep 08, 2010 4:46 pm ] |
| Post subject: | |
Google Omori tacho wiring. There's quite a few hits. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|