had to take the tank out to change the gasket as it was leaking but now I can't remember which way is up
| ausmini https://www.ausmini.com/forums/ |
|
| which way to Full https://www.ausmini.com/forums/viewtopic.php?f=2&t=66231 |
Page 1 of 1 |
| Author: | gafmo [ Sun Oct 10, 2010 1:05 pm ] |
| Post subject: | which way to Full |
had to take the tank out to change the gasket as it was leaking but now I can't remember which way is up
|
|
| Author: | GT mowog [ Sun Oct 10, 2010 1:33 pm ] |
| Post subject: | |
From your pic ^ if the float arm moves down & to the right, that should be full. |
|
| Author: | goodie [ Mon Oct 11, 2010 4:33 am ] |
| Post subject: | |
Do the screw holes line up in any position?, i have found some senders will only fit up in the one position. |
|
| Author: | GT mowog [ Mon Oct 11, 2010 6:37 am ] |
| Post subject: | |
goodie wrote: i have found some senders will only fit up in the one position.
Quite true, all sender will only line up one way, so the float doesn't contact one of the internal baffles. |
|
| Author: | Irish Yobbo [ Mon Oct 11, 2010 11:59 am ] |
| Post subject: | |
Which way to full? Most fuel tanks fill from the bottom up |
|
| Author: | GT mowog [ Mon Oct 11, 2010 1:21 pm ] |
| Post subject: | |
Irish Yobbo wrote: Which way to full? Most fuel tanks fill from the bottom up
Not Vans, well, not Gafmo's anyway. |
|
| Author: | gafmo [ Mon Oct 11, 2010 6:52 pm ] |
| Post subject: | |
GT mowog wrote: goodie wrote: i have found some senders will only fit up in the one position. Quite true, all sender will only line up one way, so the float doesn't contact one of the internal baffles. Thanks for that ill put it back in tomorrow now 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|