Morris 1300 automatic.
I run one (converted to manual) in my 1360.
| ausmini https://www.ausmini.com/forums/ |
|
| Eng No. ID https://www.ausmini.com/forums/viewtopic.php?f=2&t=66300 |
Page 1 of 1 |
| Author: | SuperCooper [ Wed Oct 13, 2010 8:59 pm ] |
| Post subject: | Eng No. ID |
12YE/A/H2205 1275 Auto from............ A Moke? Anyone? Thanks. |
|
| Author: | drmini in aust [ Wed Oct 13, 2010 9:11 pm ] |
| Post subject: | |
Morris 1300 automatic. I run one (converted to manual) in my 1360.
|
|
| Author: | SuperCooper [ Wed Oct 13, 2010 9:16 pm ] |
| Post subject: | |
Thanks Dr , the cam bearing nearest the oil pump seems to be not as wide? What bore is your stroker? 73mm? This block is std bore - a Virgin! |
|
| Author: | drmini in aust [ Wed Oct 13, 2010 9:20 pm ] |
| Post subject: | |
SuperCooper wrote: Thanks Dr , the cam bearing nearest the oil pump seems to be not as wide?
What bore is your stroker? 73mm? This block is std bore - a Virgin! The rear cam bearing shell is narrow (same as a smallbore block) because the recess for the BIG automatic pump is deeper. Using an auto block in a manual needs mods, and an oil pump spacer. Read my sticky in the mods forum. Yep my 1412 stroker is 73mm bore. Stroke is 84.33mm. |
|
| Author: | TheMiniMan [ Wed Oct 13, 2010 9:45 pm ] |
| Post subject: | |
I have oil pump adaptor plates in stock |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|