ausmini
https://www.ausmini.com/forums/

oil pressure
https://www.ausmini.com/forums/viewtopic.php?f=2&t=66333
Page 1 of 1

Author:  blake12345 [ Fri Oct 15, 2010 7:48 pm ]
Post subject:  oil pressure

Hey i had a quick look but couldnt see anything.

Ive just installed a oil pressure gauge and im wondering what a decent oil pressure would be in my 1100cc?


Thanks Blake

Author:  GT mowog [ Fri Oct 15, 2010 7:57 pm ]
Post subject: 

Cold it could reach 100 psi, but anything over 60 would be quite good.

Hot over 25 psi but closer to 40 would be happier.

Author:  blake12345 [ Fri Oct 15, 2010 8:05 pm ]
Post subject: 

ok cool thanks do it reading about 70 when i first turned the car on is ok?

Also whats the lowest the oil pressure can get before it starts to be dangerous?

Author:  drmini in aust [ Fri Oct 15, 2010 8:08 pm ]
Post subject: 

A fresh motor should have 60psi hot @ 2500rpm and up, unless it's a Cooper or S- they run about 70psi when new.
Once an engine gets down to 40psi max when hot it needs new bearings and/or a new pump, in my experience.
Hot idle, down to 15psi is OK, it's not too bad yet.

Author:  GT mowog [ Fri Oct 15, 2010 8:11 pm ]
Post subject: 

70 sounds good. The relief valve should be set somewhere around there anyway.

Hot at idle, I would want to see no less than 15 but would be happier with 20. On drive, hot, no less than 30.

Author:  blake12345 [ Fri Oct 15, 2010 8:13 pm ]
Post subject: 

Ok cool thanks. Its a fresh engine thats done about 1200k's.

Author:  gafmo [ Fri Oct 15, 2010 8:13 pm ]
Post subject: 

70 is perfect

when she starts to get low pressure (below 25ish) top the oil up or change the oil & filter. if it doesn't rise its more investigation

Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/