poeee wrote:
PO on my blue clubman used a 50mm roof screw. I won't tell anyone that I put the tank back in with the same roof screw.
I won't, its not like this is the internets or anything
| ausmini https://www.ausmini.com/forums/ |
|
| Bright idea on the tank bolt https://www.ausmini.com/forums/viewtopic.php?f=2&t=66612 |
Page 1 of 1 |
| Author: | Wombat [ Fri Oct 29, 2010 6:32 pm ] |
| Post subject: | Bright idea on the tank bolt |
I must have done a better job of putting the tank back this time and it it tucked in nice a snug but the retaining strap bolt is nigh on impossible to reach - what do people do/use to tighten it up? |
|
| Author: | drmini in aust [ Fri Oct 29, 2010 6:34 pm ] |
| Post subject: | |
3/8 drive 1/2" socket and extension bar. |
|
| Author: | Wombat [ Fri Oct 29, 2010 6:40 pm ] |
| Post subject: | |
Tried that - can't get in the top real good - just thought might try the universal joint connection to follow the curve of the tank around so to speak. |
|
| Author: | Morris 1100 [ Fri Oct 29, 2010 6:42 pm ] |
| Post subject: | |
I use a uni joint on a 3/8th drive. I use a rattle gun (suitably turned down) to get it straight without pulling sideways. |
|
| Author: | GT mowog [ Fri Oct 29, 2010 6:43 pm ] |
| Post subject: | |
I use a 1/4"Drive set with a looooong extension (about 500 mm long) and a 13mm socket. 1/2" is the correct sixe but the 13mm is a little bigger so doesn't need to line up as accurately. |
|
| Author: | poeee [ Fri Oct 29, 2010 7:57 pm ] |
| Post subject: | |
PO on my blue clubman used a 50mm roof screw. I won't tell anyone that I put the tank back in with the same roof screw. |
|
| Author: | Mick [ Fri Oct 29, 2010 8:01 pm ] |
| Post subject: | |
poeee wrote: PO on my blue clubman used a 50mm roof screw. I won't tell anyone that I put the tank back in with the same roof screw.
I won't, its not like this is the internets or anything
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|