ausmini https://www.ausmini.com/forums/ |
|
Late rover wiring loom question https://www.ausmini.com/forums/viewtopic.php?f=2&t=66620 |
Page 1 of 1 |
Author: | Harley [ Sat Oct 30, 2010 2:22 pm ] |
Post subject: | Late rover wiring loom question |
Hi people, just wondering if anyone with a late model rover can tell me the path the rear wiring loom takes from the dash to the boot? I'm sure it runs along the floor, but specifically I want to check whether it goes over or through the crossmember, and where the holes and grommets are in the rear bin/ seat area. Thanks. ![]() |
Author: | MiniDna [ Sat Oct 30, 2010 2:33 pm ] |
Post subject: | |
Hi, Yes it goes over or through the crossmember under the passnger side |
Author: | Harley [ Sat Oct 30, 2010 2:41 pm ] |
Post subject: | |
Sorry but that doesn't help me understand. Don't suppose I can trouble anyone for photos? ![]() |
Author: | MiniDna [ Sat Oct 30, 2010 3:09 pm ] |
Post subject: | |
I take pictures and post it when I go home tonight mate |
Author: | MiniDna [ Sat Oct 30, 2010 8:37 pm ] |
Post subject: | |
Hi Harley, Here is some pictures I hope that is the one you looking for. ![]() By minidna ![]() By minidna |
Author: | KLAS [ Sat Oct 30, 2010 10:11 pm ] |
Post subject: | |
the factory wiring loom goes unter the crossmenber, one channel at the floor should be a bit bigger than the others. than it goes into the rear side pocket and than to the booth IIRC |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |