| ausmini https://www.ausmini.com/forums/ |
|
| Side cover seals - how tight? https://www.ausmini.com/forums/viewtopic.php?f=2&t=67052 |
Page 1 of 1 |
| Author: | jme [ Tue Nov 16, 2010 7:40 pm ] |
| Post subject: | Side cover seals - how tight? |
I am fitting new cork seals on the side covers. How tight should the bolt be done up? |
|
| Author: | GT mowog [ Tue Nov 16, 2010 7:56 pm ] |
| Post subject: | |
If they are the raise type, 2 ft/lbs and the depressed type 5 ft/lbs. See if you can get a hold of the Neoprene ones, they are much better. |
|
| Author: | jme [ Wed Nov 17, 2010 7:01 pm ] |
| Post subject: | |
How can I tell the difference between raised and depressed? |
|
| Author: | GT mowog [ Wed Nov 17, 2010 7:05 pm ] |
| Post subject: | |
jme wrote: How can I tell the difference between raised and depressed?
With the raise ones the centre where the bolt goes through, sits higher than the gasket face. The depressed one is the other way. Any chance of a pic? |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|