GT mowog wrote:
TheMiniMan wrote:
only about 1/4 inch,,, shouldn`t be an issue with the weber box as most weber manifolds lift up away from the head quite a fair bit
I've actually measured it at 3/8" on a few un-machined blocks.
Me too.
| ausmini https://www.ausmini.com/forums/ |
|
| 998 height vs 1275 https://www.ausmini.com/forums/viewtopic.php?f=2&t=67151 |
Page 1 of 1 |
| Author: | willy [ Sun Nov 21, 2010 9:57 pm ] |
| Post subject: | 998 height vs 1275 |
as per title; how much taller is the 1275 than a 998/1100? I am in the process of making a weber box for my Moke, and need to start dimensioning up some things. |
|
| Author: | TheMiniMan [ Sun Nov 21, 2010 10:01 pm ] |
| Post subject: | |
only about 1/4 inch,,, shouldn`t be an issue with the weber box as most weber manifolds lift up away from the head quite a fair bit |
|
| Author: | willy [ Sun Nov 21, 2010 10:04 pm ] |
| Post subject: | |
Excellent. 6mm should be neither here nor there. I am running a GR 5" (or is it 7, I forget.... - anyway his normal road one) manifold, so will need to relieve the firewall to suit. Going to be running 'socks' over ramtubes. |
|
| Author: | GT mowog [ Mon Nov 22, 2010 4:31 am ] |
| Post subject: | |
TheMiniMan wrote: only about 1/4 inch,,, shouldn`t be an issue with the weber box as most weber manifolds lift up away from the head quite a fair bit
I've actually measured it at 3/8" on a few un-machined blocks. |
|
| Author: | drmini in aust [ Mon Nov 22, 2010 6:27 pm ] |
| Post subject: | |
GT mowog wrote: TheMiniMan wrote: only about 1/4 inch,,, shouldn`t be an issue with the weber box as most weber manifolds lift up away from the head quite a fair bit I've actually measured it at 3/8" on a few un-machined blocks. Me too.
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|