Let me guess: obtained a dodgy tacho off someone's mate Guido out of his fully sick Excel?
Get the brand of the thing and check out the manufacturers wesite for wiring info.
| ausmini https://www.ausmini.com/forums/ |
|
| how to put in aftermarket rev tacho https://www.ausmini.com/forums/viewtopic.php?f=2&t=67975 |
Page 1 of 2 |
| Author: | (SuX-855) [ Sat Jan 01, 2011 5:09 pm ] |
| Post subject: | how to put in aftermarket rev tacho |
has anyone put a after market rev guage in there mini and how did you do it cheers in advance |
|
| Author: | Convertible Mini [ Sat Jan 01, 2011 7:08 pm ] |
| Post subject: | After market Tacho |
Every tacho you buy should have wiring instructions with it. Failure to wire it the way instructions say will result in Damaging the Gauge permanently. It is very simple if you follow instructions. |
|
| Author: | (SuX-855) [ Sat Jan 01, 2011 8:47 pm ] |
| Post subject: | |
when i got it it didnt come with instructions |
|
| Author: | Harley [ Sat Jan 01, 2011 8:59 pm ] |
| Post subject: | |
Let me guess: obtained a dodgy tacho off someone's mate Guido out of his fully sick Excel?
Get the brand of the thing and check out the manufacturers wesite for wiring info.
|
|
| Author: | (SuX-855) [ Sat Jan 01, 2011 9:03 pm ] |
| Post subject: | |
its a typeR rev guage |
|
| Author: | Hanra [ Sat Jan 01, 2011 9:23 pm ] |
| Post subject: | |
Does it have Red, Black, White, Green wires? |
|
| Author: | (SuX-855) [ Sat Jan 01, 2011 10:43 pm ] |
| Post subject: | |
its got red black yellow and green and a extra red n yellow for shift light |
|
| Author: | Hanra [ Sat Jan 01, 2011 11:32 pm ] |
| Post subject: | |
My un educated guess would be: Red: Switched 12v source from your IGN key when in ON position. Black: Ground Green: Neg on the Ign Coil Yellow: Switched 12v source from your lighting circut. |
|
| Author: | GT mowog [ Sun Jan 02, 2011 6:56 am ] |
| Post subject: | |
(SuX-855) wrote: a extra red n yellow for shift light
Fuuuuulllllyyyyyyyyy sic, dude |
|
| Author: | woodwormm [ Sun Jan 02, 2011 1:10 pm ] |
| Post subject: | |
i put in a speco one a couple years back... i had to get a diode from dick smiths (back when they had electronics stuff) and wire it into the feed from the dizzy to compensate for some major needle jittering... and this was in the speco instructions for certain vehicles.... my useless fact for the day, but it is still early.... |
|
| Author: | (SuX-855) [ Sun Jan 02, 2011 3:37 pm ] |
| Post subject: | |
thanx for everyones reply now just gotta figure out where to install it in the mini |
|
| Author: | MiNi MuLiShA [ Sun Jan 02, 2011 4:03 pm ] |
| Post subject: | |
Extra 200KillaWasps. Right there. |
|
| Author: | Harley [ Sun Jan 02, 2011 4:39 pm ] |
| Post subject: | |
Mines bigger than yours Cam. 
|
|
| Author: | MiNi MuLiShA [ Sun Jan 02, 2011 5:01 pm ] |
| Post subject: | |
Harley wrote: Mines bigger than yours Cam.
Its not how big it is Harlski, its how ya throw it around 
|
|
| Author: | (SuX-855) [ Sun Jan 02, 2011 7:57 pm ] |
| Post subject: | |
i cant install mine there got no roll cage |
|
| Page 1 of 2 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|