| ausmini https://www.ausmini.com/forums/ |
|
| fitting new cwp https://www.ausmini.com/forums/viewtopic.php?f=2&t=68001 |
Page 1 of 1 |
| Author: | justfanginaround [ Mon Jan 03, 2011 10:21 am ] |
| Post subject: | fitting new cwp |
I have been advised that if I wish to put a 3.1 cwp into my gearbox i will need to grind some bearing carrier ? Any advise or susgestions ? Has anyone done this before ? cheers Jon |
|
| Author: | drmini in aust [ Mon Jan 03, 2011 10:37 am ] |
| Post subject: | |
The bigger pinion can foul inside the 3rd motion shaft bearing carrier. If it's a rodchange box it should/might be OK, but all remote change boxes need the carrier's inside diameter increased to 57mm approx. It's a 5 min job in a lathe. 
If no lathe you can grind it out by hand, it's only clearance. |
|
| Author: | justfanginaround [ Mon Jan 03, 2011 11:07 am ] |
| Post subject: | |
cool thank you the great wise doc. is it g/box off engine job or can i do it carefully through the diff opening ? |
|
| Author: | GT mowog [ Mon Jan 03, 2011 11:12 am ] |
| Post subject: | |
If it's needed, you can get it off through the end cover. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|